Display the name of the running image file using the show boot command from the Privileged EXEC mode prompt as follows: ALSwitch#show boot BOOT path-list: Config file: flash:config.text Enable Break: no Manual Boot: no HELPER path-list: NVRAM/Config file buffer size: 32768 ALSwitch# b. Step 4 Display the name of the running image file a. If the answer is no, troubleshoot the host and switch configurations. To verify that the host and switch are correctly configured, ping the switch IP address from the host. Step 2 Configure the host attached to the switch Configure the host to use the same IP subnet for the address, mask, and default gateway as on the switch. If problems occur while performing this configuration, refer to the Basic Switch Configuration lab. Step 1 Configure the switch Configure the hostname, access, and command mode passwords, as well as the management LAN settings. Perform those steps on all switches in this lab assignment before continuing.ĬCNA 3: Switching Basics and Intermediate Routing v 3.1 - Lab 6.2.9 Note: Go to the erase and reload instructions at the end of this lab. This lab requires that there is a saved copy of the current configuration file as backup.
How to access flash on cisco 2950 switch update#
The IOS update release contains new HTML files to support changes to the web interface.
However, for the purpose of the lab, assume that this is an update. This has the same file name stem as the current image. It has been determined that this file is the latest update for the Catalyst 2950. This file should be downloaded by the instructor from the Cisco Connection on-line software center. Notes: This lab requires that a combination of an IOS image and the HTML file called c2950c3h2s-mz.120-5.3.WC.1.tar be placed in the default TFTP server directory (folder) by the instructor or student. The following steps are to be executed on each switch unless specifically instructed otherwise. Any other switch used may produce different output. The configuration output used in this lab is produced from a 2950 series switch. Upgrade the IOS and HTML files from a file supplied by the instructor.īackground/Preparation Cable a network similar to the one in the diagram. Lab 6.2.9 Firmware Upgrade of a Catalyst 2950 Series SwitchĬreate and verify a basic switch configuration.
0 kommentar(er)
